What's up guys, hope you are all having a nice day
I need some help with a drive i'm flashing for a customer. The problem is, I create the CFW and then go to write it, but then when I outro the drive JF says it's not detected and the drive is fully unresponsive and basically is bricked until I unlock it again. My firmware does this to whatever PCB I write it to. I have tried a phat 16d2s, d4s unlocked, and d5s unlocked pcb. All 3 do the same thing. It writes, then bricks after outro.
Have I gone rusty and am missing something here? Feel free to roast me if needed, I can handle it.
Any help is appreciated,
Thanks
-Logan
Before you start asking, yes I have tried different PC's and different JF versions. I am using a X360 USB Pro v1 rev 5
Oddly enough, if I flash any D5S FW it works fine after outro
Is there like some sort of workaround I can use?
I need some help with a drive i'm flashing for a customer. The problem is, I create the CFW and then go to write it, but then when I outro the drive JF says it's not detected and the drive is fully unresponsive and basically is bricked until I unlock it again. My firmware does this to whatever PCB I write it to. I have tried a phat 16d2s, d4s unlocked, and d5s unlocked pcb. All 3 do the same thing. It writes, then bricks after outro.
Have I gone rusty and am missing something here? Feel free to roast me if needed, I can handle it.
Any help is appreciated,
Thanks
-Logan
Before you start asking, yes I have tried different PC's and different JF versions. I am using a X360 USB Pro v1 rev 5
Oddly enough, if I flash any D5S FW it works fine after outro
Is there like some sort of workaround I can use?