ive got a v6 corona, I have read the nand a few times fine with the r/w qsb kit, soldered up a cr3lite with the fake post out then wrote the ecc, but when I turned the console on its dead - no power the psu stays orange. so I had a good look over the board but cant see any solder bridges etc. I then took the cr3lite off and wrote the retail nand back - still no power. just wondering if anyone has had this and sorted it or you any of you stars could help. fingers crossed. many thanks for any help EDIT; OMG forget everything I just wrote it was my psu. I just used my mates one and it booted up no problem (what a bell end I am)
↧