I was trying to do my first Corona v2 the other day, and while trying to apply the QSB I misaligned it just a touch where I wasnt able to connect all the points.
I tried to desolder and remove it and accidentally lifted the #2 pad :( Never had much luck with damn QSBs anyway, Im a wire guy.. I have done some research and found this
![Click image for larger version.
Name: Zikai.jpg
Views: 26
Size: 149.8 KB
ID: 7189]()
But my question is if I still need to read/write where would I connect the wire to? Scratch the trace above or below and connect?
Or jumper the trace and then solder to that wire? I am going to try and just run wires from the QSB to Nand since the repair likely wont allow it to fit. Thanks for any input, most of the posts I have found have been once people were done with the RGH and trying to remove the QSB, not something happening from the beginning.
I tried to desolder and remove it and accidentally lifted the #2 pad :( Never had much luck with damn QSBs anyway, Im a wire guy.. I have done some research and found this
But my question is if I still need to read/write where would I connect the wire to? Scratch the trace above or below and connect?
Or jumper the trace and then solder to that wire? I am going to try and just run wires from the QSB to Nand since the repair likely wont allow it to fit. Thanks for any input, most of the posts I have found have been once people were done with the RGH and trying to remove the QSB, not something happening from the beginning.